Our stickers are printed on high quality vinyl.

We manually mix the inks to match the original LEGO colours.

Yes, our stickers are precut. So you can peel them

We recommend to carefully remove the outer edges of the sheet first.
The necessary stickers will remain behind.
With the help of, for example, a hobby knife you can easily remove the stickers.

The bricks must be clean and grease-free.
The adhesive needs to melt. You can achieve this by pressing the sticker firmly. This warms up the adhesive layer, allowing it to bond better.

1. Remove Lego® Sticker using Vaseline and a Hair Dryer
You will need:
• Vaseline
• Hairdryer
• Damp Cloth
• Dish Detergent
Instructions:
Apply a generous amount of Vaseline to the Lego® sticker. (Make sure the sticker is completely coated.)
1. Using a hair dryer, heat the coated part of the sticker. (We recommend placing the Lego® bricks on a piece of cloth when heating. The cloth will absorb the melted Vaseline.)
2. To remove the Lego® sticker off the bricks, start on the edge of the sticker by lifting it up.
3. Pull it off using your finger.
4. Wipe any residue left on the Lego® bricks with a damp cloth.

2. Remove Lego® Sticker Easily with WD40 Lubricant Silicone Spray
You will need:
• Dishwashing detergent
• WD 40 Lubricant Silicone Spray
• Paper towel
• Tub of water
• Dull knife
Instructions:
1. Using your fingernail or a dull knife, remove Lego® sticker by pulling it from its edge.
2. Spray an ammount of WD40 on the stickers.
3. Rub off any glue residue with a paper towel until the residue is completely gone.
4. Immediately soak the Lego® bricks in a tub of water to remove the paint thinner.
5. Take the Lego® bricks out of the tub and transfer them to a second tub with a diluted dishwashing detergent. Soak it for about 20 minutes.
6. Clean off Lego® bricks with water, then dry them with a clean towel.